Press and hold the Restore button on your camera.Connect the camera to your DVR / NVR with an Ethernet cable to the PoE ports.To restore your camera(s) to default settings: Click here for downloads and documentation for your product. REMINDER: Refer to your user manual for model specific locations of the Restore button. If you set static IP addresses on the camera(s) and they are not connecting, restore the camera(s) to default settings. If the camera does not connect, try a different power source.To power cycle your IP camera, please power off and disconnect the power source for approximately 30 seconds.Stream Example: rtsp://192.168.1.210:554/LiveChannel/0/media.smpĮxample URL - rtsp://192.168.1.If you have recently changed your network router and your IP cameras are not connecting, check the IP settings in either your camera or your connected DVR / NVR. Note: LiveChannel/0/ where “0” equals the channel number. They sometimes use the Hikvision APIsĮxample URL: rtsp://192.168.1.210/h264.sdp You may have to contact support for your specific model. Note: Swann uses various lines of hardware and software and RTSP streams. Swann camera RTSP where 0 = mainstream and 1 = substream Samsung / Hanwha Techwin Camera RTSP - stream type either 1 for mainstream or 2 for substreamĮxample URL: will bring up mainstream for a camera on 192.168.1.210 c1 would be channel 1, c2 channel 2, etcĮxample URL: will bring up substream for channel 2.Įxample URL rtsp://192.168.1.210/axis-media/media.ampĪvigilon RTSP RTSP streams must be generated in the web UI of the camera under compression and image rate. You can also encode credentials into the URL by entering it prior to the IP address - for example.Įxample URL: will bring up mainstream for channel 1, where admin is the username and 12345 is the password. This RTSP stream would mainstream channel 1 on an NVR at 192.168.1.210. 201 would produce the channel #2 of the NVR and mainstream and 202 would produce channel #2 and substream.Įxample: rtsp://192.168.1.210:554/Streaming/Channels/101 Changing the to 102 would create channel 1 and stream #2. streaming channel - for example “101” would be channel 1 and stream #1 (mainstream). The of main stream is 0, extra stream 1 is 1, extra stream 2 is 2.Įxample URL: will bring up substream for channel 1 Some Common RTSP URLS: Dahua RTSP stream (Cameras & - the IP address of the IP Camera. This will indicate if the camera is having a bandwidth issue and is dropping packets. When we are testing for packet loss you will select "Tools" and then "Codec Information". If all is successful it will display the RTSP stream. Enter the Camera specific RTSP stream.Īfter entering in the URL and pressing Play you should be prompted to put in the cameras Username and Password. You must test it with VLC because the way the software pulls the stream in is through RTSP on port 554.ģ. Navigating to the cameras web interface does not mean that the camera will work. If a camera cannot connect using VLC it will give us a better idea of what is going on with the camera. This is to test the RTSP stream and make sure it is connecting. You will have to test the camera using VLC media player. You may run into issues with a camera connecting or after setting up a camera you may see a red X.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |